THERMAX Wall System Fasteners

Manufacturer	Fastener/Veneer Tie	Description
Wind-Lock www.ci-lock.com 1-800-872-5625	ci-LOCK Fasteners and Washers	Made of high-grade polypropylene Unique design allows plate to flatten out in application Large ribs stiffen plate, limit deflection

Manufacturer	Fastener/Veneer Tie	Description
Heckmann Building Products www.heckmannbuildingprods.com 1-800-621-4140	POS-I-TIE System Original POS-I-Tie shown; Wing nut and thermal designs also available	Two-piece system for attaching brick veneer to various exiting backups Incorporates barrel-screw piece, which allows easy installation Neoprene washer helps prevent moisture penetration by sealing the hole in insulation/gypsum board backup
	Drill Bolt System	Attaches to stud side U-Clip adjusts rotationally from outside Slot can be installed up or down, allowing for vertical adjustment
FERO www.ferocorp.com 1-780-455-5098	Slotted Stud Tie (Type II)	Developed for brick veneer steel stud wall construction where significant differential movement between the veneer and the stud backup wall is expected, such as high walls or multi-story buildings with full height veneer Assembly consists of slotted stud plate (Type II), FERO V-Tie and an optional insulation support
Hohmann & Barnard www.h-b.com 1-800-645-0616	X-SEAL Anchor	Prolonged legs bridge sheathing and abut steel stud, enabling independent, positive anchorage and helping prevent compression of sheathing by positive loads
Dayton Superior www.daytonsuperior.com 1-877-632-9560	Dur-O-Wal Veneer Anchors	DA210X: Legs pierce through rigid foam insulation, allowing transfer of compression loads directly to steel stud backing DA213: Recommend two fasteners per plate

Ready to make your mark? We'll do our level best to answer your questions.